Rigol DS1000D User Manual download pdf (Page 125)

RIGOL

User’s Guide for DS1000E, DS1000D Series

2-95

To Measure with Cursors

Figure displays the Cursor button on the front-panel.

Figure 2- 133

Cursor measurement setup button

The cursor measurement has three modes: Manual, Track and Auto Measure.

1. Manual Mode:

In this mode, the screen displays two parallel cursors. Move the cursors to make

custom voltage or time measurements of the signal. The values are displayed on the

boxes below the menu. Before using cursors, make sure to set the Signal Source as

the channel for measuring.

2. Track Mode:

In this mode, the screen displays two cross cursors. The cross cursor sets the

position on the waveform automatically. Adjust cursor’s horizontal position on the

waveform by rotating the multifunctional knob (

). The oscilloscope displays the

values of the coordinates on the boxes below the menu.

3. Auto Mode:

This mode will take effect with Automatic Measurements. The instruments will

display cursors while measuring parameters automatically. These cursors

demonstrate the electrical meanings of these measurements.

NOTE: The Auto Measure mode for Cursor measuring will take no effect without

automatic measurements.

Cursor measurement setup button

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 165 166

No comments

Rigol DS1000D User Manual Page 125