RIGOL 安装指导 Installation Guide © 2013 RIGOL Technologies, Inc. All Rights Reserved. DS1000Z/DG4000 机架套件 DS1000Z/DG4000 Rack Mount Ki
-1- 产品简介 Product Overview 使用本机架套件可将 RIGOL DS1000Z 系列数字示波器或 DG4000 系列函数/任意波形发生器安装到 19 英寸标准机柜内。本手册以 DG4000 为例介绍安装方法。 Using this rack mount kit, you can
-2- 部件示意图 Parts Schematic Diagram 2-1 2-2 2-3
-3- 安装工具 Installation Tool 推荐使用 PH2 号头十字改锥。PH2 Phillips Screwdriver (recommended). 安装空间 Installation Space 本机架安装到机柜内须满足如下要求: 机柜必须为 19 英寸标准机柜。
-4- 安装步骤 Installation Procedure 仅授权人员方可执行安装操作,不正确的操作可能导致仪器损坏或不能正确安装到机架内。 Only authorized operators can execute the installation operation. Improper
-5- 2. 安装机架前面板:将前面板用 6 颗 M4 螺钉固定在上一步装好的框架上。 Install the front panel of the rack mount kit: fix the front panel onto the frame installed in the prev
-6- 4. 固定仪器上部:将两个固定件压紧仪器上部,用 4 颗 M4 螺钉固定。 Fix the top of the instrument: fix the top of the instrument using two built-in fittings and four M4 scre
-7- a standard 19-inch machine cabinet with four M6 screws and four M6 square nuts. 6. 安装后注意:机架占 4U 高度,箭头所指的孔为机架的安装孔,注意对准安装。 Post-installation noti
Comments to this Manuals