RIGOL
© 2008 RIGOL Technologies, Inc.
Programming Guide for DM3000 Series
Programming Introduction
This part intrduces the basic programming operations.These programming commands
provide the methods for remote control to a multimeter.
The Basic operations that you can do with a computer and a multimeter include:
Setup a multimeter.
Measure.
Receive data (equipment working condition or measurement results) from a
multimeter.
A computer can communicate with a multimeter by sending and receiving messages
over an I/O port, such as USB, GPIB port or a RS-232 port. The commands appear as
ASCII strings embedded inside the output statements of a “host” language available
on your computer, so users can control and do the secondary development. Please
refer to the user guide about the connection methods of communication interface.
Comments to this Manuals