Rigol DS6000 Series User Manual download pdf (Page 56)

RIGOL

DS6000 Quick Guide

Figure 7 To Connect the Probe

Function Inspection

1. Press SAVE  Factory to restore the oscilloscope to its default configuration.

2. Use the probe to connect the input terminal of channel 1 (CH1) of the

oscilloscope and the “Compensation Signal Output Terminal” of the probe.

Figure 8 To Use the Compensation Signal

3. Connect the earth alligator clip of the probe to the “Ground Terminal” under the

probe compensation signal output terminal.

4. Press the Auto key.

5. Observe the waveform on the display. In normal condition, the display should be

a square waveform as shown in the figure below:

Figure 9 Square Waveform Signal

Compensation Signal Output Terminal

Ground Terminal

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 78 79

No comments

Rigol DS6000 Series User Manual Page 56