RIGOL DG10X2 Commands System
Programming Guide for DG10X2
FREQuency
FREQuency commands are used for setting: the frequency of output function from
dual channels; the start frequency, the center frequency or the span frequency in
sweep mode, the carrier frequency in modulation. Sweep and modulation are only
valid for CH1.
DG10X2 supports following FREQuency commands:
1. FREQuency
2. FREQuency?
3. FREQuency:CH2
4. FREQuency:CH2?
5. FREQuency:STARt
6. FREQuency:STARt?
7. FREQuency:STOP
8. FREQuency:STOP?
9. FREQuency:CENTer
10. FREQuency:CENTer?
11. FREQuency:SPAN
12. FREQuency:SPAN?
The detailed information of each command are:
FREQuency {<frequency>|MINimum|MAXimum}
Set the frequency of output function for CH1.
<frequency> is the frequency value set by user, the default unit is
Hz. MIN is the minimum frequency permitted by specified function,
MAX is the maxmum.
FREQuency? [MINimum|MAXimum]
Query the frequency of output function from CH1.
Comments to this Manuals