Rigol DG2000 Series User's Guide download pdf (Page 23)

RIGOL

User’s Guide for DG2000 Series

1-13

To Set Trigger/Output

As shown in figure 1-20, there are two buttons on the right side of the operation panel,

which are used to set Trigger and Output Control. The instruction below will help you

familiarize with these functions.

Figure 1-20 The Trigger/Output Button

1. Press Trigger Button, choose internal/external or manual Trigger (Manual Trigger

can only be used in Sweep and N-Cycle Burst)

 The default setting for Trigger is “Internal”. In this mode, when the Sweep or

Burst Mode is also selected, the Generator will continuously generate burst.

At this time, press Trigger button, the instrument will shift from the

“Automatic” Trigger mode into “Manual” Trigger mode.

 When the generator uses the” External” Trigger Mode, if the Sweep or the

Burst Mode is selected, the signal will be continuously generated. At this time,

press Trigger button, the instrument state will not change, and it will show

the information “The instrument has already been triggered”.

 Every time you press the Trigger button, “Manual” Trigger will start a sweep

or generate a burst. Press the button again, and the generator will be

triggered again.

2. Press Output Button, activate or deactivate the output signal.

If an overload message is shown, disconnect the external equipment from the

output terminals and press Output button, reactivate the output terminal.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 158 159

No comments

Rigol DG2000 Series User's Guide Page 23