Rigol DP832 User Manual download pdf (Page 98)

RIGOL Chapter 2 Front Panel Operations

2-48 DP800 User’s Guide

 Chinese Input

In Chinese input method, use the knob to select the desired Pinyin

character in the "Virtual Keyboard" and press Select to select this character;

the character selected is displayed in the "Pinyin Input Area" (at this point,

you can press 0 on the numeric keyboard to directly input the English

characters in the "Pinyin Input Area"). After inputting the pinyin of a

Chinese character, select the number of the desired Chinese character using

the numeric keyboard in the "Chinese Character Selection Area" (if the

or/and

icon at the right side of the "Chinese Character Selection Area"

is illuminated, you can use the up/down direction key to turn to the

previous or next page) and the Chinese character selected is displayed in

the "Filename Input Area". Use the same method to input all the Chinese

characters in the filename.

The length of the filename cannot exceed 9 characters (a Chinese character

occupies 2 characters). During the input, you can press Delete

continuously to delete the characters in the "Pinyin Input Area" from right

to left if there are characters in the "Pinyin Input Area" or you can press

Delete to delete the Chinese character currently at the left of the cursor in

the "Filename Input Area" if there is not character in the "Pinyin Input

Area".

Note:

 Chinese input is not supported in uppercase state. To use the Chinese

input method, press . to select lowercase state.

 In Chinese input method, after a number in the "Virtual Keyboard" is

selected using the knob, press Select to select this number and the

number will be directly displayed in the "Filename Input Area".

Figure 2-12 Filename Input Interface (Chinese)

Pinyin Input Area Virtual Keyboard

Filename Input Area Chinese Character Selection Area

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 143 144

No comments

Rigol DP832 User Manual Page 98