Rigol DG1000 Series User's Guide Page 59

  • Download
  • Add to my manuals
  • Print
  • Page
    / 149
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 58
RIGOL
© 2008 RIGOL Technologies, Inc.
User’s Guide for DG1000
2-35
To Generate Sweep Signal
In the frequency sweep mode, the function generator “sweep” from the start
frequency to the stop frequency at the sweep rate you specify. Sweeping can be
generated by Sine, Square, Ramp or Arbitrary Waveforms (Pulse, Noise and DC are
not allowed).
Press the Sweep button, in the Normal Mode, the operation menu will appear on the
bottom of the screen. See Figure 2-43, set the Waveform parameters by using the
operation menu.
Figure 2-43
Sweep Waveform Parameter Setting Interface
Table 2-17 Waveform Sweep Setting Menu
Menu
Settings
Explanation
Linear
log
Set the Sweep with linear spacing
Set the Sweep with logarithmic spacing
Start
Center
Set the Start Frequency of the Sweep
Set the Center Frequency of the Sweep
Stop
Span
Set the Stop Frequency of the Sweep
Set the Frequency Span of the Sweep
Time
Set the Time Span of the Sweep for which the Frequency
changes from the Start Frequency to Stop Frequency.
Trigger
Source
Int: Choose Internal Source
Ext: Choose External Source, use the [Ext
Trig/FSK/Burst] connector on the rear panel
Manual: Choose manual trigger. Press Manual will
trigger a Sweep.
TrigOut
: Signal Triggered at Rise Edge
: Signal Triggered at Fall Edge
Off: Turn off Trigger Setting
Finish trigger settings
Page view 58
1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 148 149

Comments to this Manuals

No comments