Rigol DG1000 Series User's Guide Page 83

  • Download
  • Add to my manuals
  • Print
  • Page
    / 149
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 82
RIGOL
© 2008 RIGOL Technologies, Inc.
User’s Guide for DG1000
2-59
Auto Measurement Setting
Press Utility Count Auto, the instrument will set the measurement parameters:
Coupling mode, Sensitivity, Trig Level and High Frequency Restrain “On” or “Off.
Manual Measurement Setting
Press Utility Count Setup, enter the manual measurement mode.
1. To Set the Coupling Mode
Press Count Setup DC/AC, set the coupling mode.
As shown in the following figure, the soft key with “DC” or “AC” is the current
coupling mode, each time you press the key, the coupling mode will change. For
example, the current mode is “AC”, press the key, then the mode will be “DC”.
Figure 2-63
To set the coupling mode
2. To Set the Sensitivity
The sensitivity has three kinds: High, Medium and Low. Press Utility Count
Setup Sens to set the sensitivity. Press the corresponding soft key to switch
the Sensitivity.
Figure 2-64
To set the sensitivity
Suggestion:
For low amplitude signal, the “medium” or “high” sensitivity should be used.
For low frequency signal with high amplitude and slower rising edge, low
sensitivity is a better choice.
Page view 82
1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 148 149

Comments to this Manuals

No comments