Rigol DG1000 Series User's Guide download pdf (Page 18)

RIGOL

User’s Guide for DG1000 Series

1-8

To Set a Waveform

At the left of the operation panel, there is a set of buttons with waveform icon. See

Figure 1-9. The exercise below will help you to be familiar with the waveform

selection settings. The instructions of the waveform setting are all carried out in the

Menu Display Mode.

Figure 1-9

Waveform Selection Buttons

1. Press Sine button, and the waveform icon turns into Sine with a “Sine” typeface

in the state area. DG1000 Series Generator can generate Sine signal with

frequency from 1μHz to 20MHz. By setting Frequency/Period, Amplitude/ High

Level, Offset/ Low level, sine signal with different parameters can be generated.

Figure 1-10

Sine Signal in the Menu Display Mode

As shown in Figure 1-10, the default signal parameters are: 1kHz Frequency, 5.0 V

Amplitude and 0 V

DC Offset.

2. Press Square button, and the waveform icon turns into Square with a “Square”

typeface in the state area. DG1000 Series Generator can generate Square signal

with frequency from 1μHz to 5MHz and variable duty cycle. By setting

Frequency/Period, Amplitude/ High Level, Offset/ Low level, and Duty Cycle,

Square signal with different parameters can be generated.

Figure 1-11

Square Signal in the Menu Display Mode

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 149 150

No comments

Rigol DG1000 Series User's Guide Page 18