Rigol DG10X2 Series User's Guide download pdf (Page 41)

RIGOL

User’s Guide for DG10× 2 Series

To Set Noise Waveform

Press the Noise button, in the Normal Mode, the operation menu will appear at the

bottom of the screen. Set the Noise parameters by using the operation menu.

The parameters for Noise waveforms are: Amplitude/ High Level and Offset/ Low

Level. See Figure 2-17, in the operation menu, select Ampl, and the corresponding

amplitude will be displayed in inverse color for which users can make a change for the

amplitude of Noise, which has no frequency or period.

Figure 2-17

Noise Signal Parameter Setting Interface

Table 2-5 Noise Signal Operation Menu

Press View, in the Graph Mode, the waveform is shown in the following figure.

Figure 2-18

Waveform Parameter in the Graph Mode

Settings

Explanation

Amplitude/

High Level

Setting the signal’s Amplitude or High Level; the

current parameter will switch at a second press.

Offset/Low

Level

Setting the signal’s Offset or Low Level; the

current parameter will switch at a second press

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 149 150

No comments

Rigol DG10X2 Series User's Guide Page 41