RIGOL
© 2008 RIGOL Technologies, Inc.
User’s Guide for DG10× 2 Series
To Set Arbitrary Waveforms
Press the Arb button, in the Normal Mode, the operation menu will appear at the
bottom of the screen. Set the Arbitrary Waveform parameters by using the operation
menu.
Arbitrary Signals are divided into two categories: the built-in optional system
waveforms and the user-definable arbitrary waveforms. The parameters for Arbitrary
Waveforms are:
Frequency/ Period, Amplitude/ High Level, Offset/ Low Level and
Phase
. See Figure 2-19, in the operation menu, select Freq, and the corresponding
frequency will be displayed in inverse color for which users can make a change.
Figure 2-19
Arbitrary Signal Parameter Setting Interface
Table 2-6 Arbitrary Signal Operation Menu
Setting the signal’s frequency or period; the
current parameter will switch at a second press.
Setting the signal’s Amplitude or High Level; the
current parameter will switch at a second press.
Setting the signal’s Offset or Low Level; the
current parameter will switch at a second press.
Select the built-in Arbitrary Signal as Output.
Create and Edit Arbitrary Waveform.
Setting the initial phase of the signal
Comments to this Manuals