RIGOL
© 2008 RIGOL Technologies, Inc. 2-59
User’s Guide for DG10× 2 Series
To Set the Counter
The counter can automatically detect signal with amplitude from 200mVPP to 5VPP and
frequency form 100mHz to 200MHz.
Press Utility Count, the screen will display the operation menu of the counter, see
Figure 2-62. Press “Freq”, “Period”, “DutyCyc”, “PWidth/NWidth”, the instrument will
display the measured values of the frequency, period, duty cycle, positive width and
negative width.
Figure 2-62
Normal display interface of the counter
Table 2-25 Operation menu of the counter
Display the frequency of the signal to
be measure
Display the period of the signal to be
measure
Display the duty cycle of the signal to
be measure
Display the positive width of the signal
to be measure
Set the measurement parameters of
the counter automatically.
Set the measurement parameters of
the counter manually.
Press Setup to set the measurement parameters of the counter containing: AC or DC,
Sensitivity, Trig Level, High frequency restrain “On” or “Off”. Different settings make
different measurement results.
Comments to this Manuals